(1) Connector (2) Rubber Cover
2. Remove the cab.
3. Press down the socket and turn
it counterclockwise to remove the
bulb. If the bulb is blown, replace it
with a new one with the same ca-
pacity.
4. Installation is carried out in reverse
order of removal.
TE1O739A
If using a bulb other than the
specied one, the lamp can be
damaged and the tractor can
even catch re.
Make sure to use bulbs with
the specied capacity.
•
•
WARNING
Make sure to use a genuine
bulb. Us i n g a non-rec o m -
mended bulb can cause a re.
The headlamps can temporar
-
ily be fogged due to rain or
car wash. This is because of
the temperature difference be-
tween the inside and outside
of the lamp, which is normal.
•
•
CAUTION
The work lamp uses a halogen bulb.
Do not touch the illuminating part of
the halogen bulb.
The bulb life can be shortened by
finger prints, dust and moisture, or
the bulb even can be broken. Clean
it with soft cloth.
Be careful of the following when re-
placing the halogen bulb:
Replace the bulb after it is cooled
down.
Do not touch the glass of the bulb.
Handle the bulb with care and be
careful not to scratch or rub it.
Do not let the bulb contact with liq-
uid when it is illuminated.
Wear protective glasses when re-
placing the bulb.
WORKING LAMP (FRT/RR)
To Next Page
Loading...
