(1) Reservoir Tank (2) Radiator Cap
(A) FULL (B) LOW
6. Install the radiator cap securely.
7. Start and operate the engine for
few minutes.
8. Stop the engine and let cool.
9. Check coolant level of reservoir
tank and add coolant if necessary.
Model Capacity
MANUAL 2.03 U.S.gal. (7.7 L)
HST 1.0 U.S.gal. (3.75 L)
To avoid accidents:
D o no t re m o v e th e ra d i a -
tor cap while the coolant is
hot. You can get burnt by hot
steam. Make sure to remove
it after the coolant is cooled
down enough.
Even though the coolant is
cooled down, turn the cap to
its rst stop and then wait un-
til it is depressurized before
removing the cap completely.
•
•
CAUTION
Do not start engine without
coolant.
Use clean, fresh water and
anti-freeze to fill the radiator
and reservoir tank.
When the anti-freeze is mixed
with water, the anti-freeze mix-
ing ratio must be less than
50%.
•
•
•
IMPORTANT
Securely tighten radiator cap.
If the cap is loose or improp-
erly tted, water may leak out
and the engine could over-
heat.
If the radiator cap has to be
removed, follow the caution
above and securely retighten
the cap.
Use clean fresh water and
anti-freeze to ll the reservoir
tank.
If the coolant leaks, contact
your local KIOTI Dealer.
•
•
•
•
IMPORTANT
TE1O759A
To Next Page
Loading...
