(1) Backup lamp (2) Mounting bolt
(3) Backup lamp bulb
TE1O743A
Unscrew the bolt to remove the
cover and undo the bolt. Then, turn
the bulb while pressing it gently to
remove it. Replace the bulb with a
new one.
BACKUP LAMP
Do not touch the bulb if it is
still illuminated or right after it
is turned off. You can be burnt
by the hot bulb.
For some bulbs which require
delicate handling or work pro-
cess, contact your local KIOTI
Dealer.
Do not touch the illuminating
glass part of the halogen bulb.
The bulb life can be shortened
by fing e r print s , dust a nd
moisture, or the bulb even can
be broken. Clean it with soft
cloth.
The halogen bulb contains
compressed gas, so it can ex-
plode if dropping or scratch-
ing it. Therefore, never use a
bulb if it is scratched or was
dropped.
•
•
•
•
CAUTION
When separating the cover
by prying it off with a screw-
driver, be careful not to dam-
age it.
Before replacing a bulb, make
sure to put the key switch and
the switch for the correspond-
ing bulb to the "OFF" position.
Install a new bulb with the
same capacity after removing
the installed bulb.
•
•
•
CAUTION
To Next Page
Loading...
Need help?
General
