Chapter 1 Before Use 1-6
1. 4. 2 Printer part
Subject Specification
Printing method LED Array Electro photography
Photoreceptor Organic Photoconductive Drum
Print speed 80mm per second
(Inch) 3.4ppm/E 5.8ppm/D Landscape
(Metric) 3.3ppm/A0 5.6ppm/A1 Landscape
Print head LED Array
Resolution of print head
600dpi x 2400dpi
Print width Maximum 914mm / 36”
Minimum or 297mm / 11” (roll media)
or 210mm / 8.5” (cut sheet)
Print length Maximum
(Standard) 6,000mm / 19.7ft for 36” / A0 wide
(plain paper / bond)
or “5 x Standard length” (plain paper / bond)
“2 x Standard length”
(tracing paper / vellum)
“1 x Standard length”
(film)
(Option) 200,000mm
Minimum 210mm / 8.5”
Print size
(from Paper Tray, option)
ISO (mm)
Width
Length
ANSI (inch)
Width
Length
Warm up time Shorter than 4 minutes 30 seconds
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
First print time 21 seconds (D Landscape, Front Stacking)
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
Fusing method Heat and Pressure Rollers
Development method Dry type non-magnetic mono-component toner
NOTE
If the print is longer than 6,000mm, its image quality or the
reliability of paper feeding is not guaranteed.
594 420 297 210
420 X X
297 X X
24 22 18 17 12 11 9 8.5
18 X X
17 X X
12 X X
11 X X
NOTE
The above specifications are subject to change without notice.
To Next Page
Loading...
