5. GENERATOR USE
■To prevent electrical shock from faulty appliances, the
generator should be grounded. Connect a length of
heavy cable between the generator's ground terminal
and an external ground source.
■Connections for standby power to a building's electrical system must be made by a
qualified electrician and must comply with all applicable laws and electrical codes.
Improper connections can allow electrical current from the generator to back feed into
the utility lines. Such back feed may electrocute utility company workers or others who
contact the lines during a power outage; when utility power is restored, the generator
may explode, burn, or cause fires in the building's electrical system. Do not connect this
generator to an automatic transfer switch. Serious damage to the engine and inverter
module may result.
■ Limit operation requiring maximum power to 30 minutes.
For continuous operation do not exceed the rated power of 2800 watts or 23.3 amps.
■ Do not exceed the current limit specified for any one receptacle.
■ Do not modify or use the generator for other purpose other than what it was intended.
Also observe the following when using the generator:
Do not attempt to connect generators in parallel.
Do not connect an extension to the exhaust pipe.
Do not operate with any covers removed or in a closed compartment
■ When an extension cable is required, make sure you use the proper size and length.
16 Gauge Cord- any 16 gauge cord between 0 and 100 feet long will adequately handle tool
and appliance loads up to 10 amps
14 Gauge Cord- a 14 gauge cord between 0 and 50 feet long will adequately handle loads
between 10 and 15 amps.
12 Gauge Cords- if your load is between 10 and 15 amps and the length of the cord is 50 to
100 feet, you need a 12 gauge cord to safely power any tool.
■ Keep the generator away from other electric cables or wires such as commercial
power supply lines.
■ You may use the DC receptacle and AC power simultaneously.
To Next Page
Loading...
