5.6 DC application
The DC receptacle may be used for charging 12 volt automotive-type batteries only. It is
not designed to operate DC motors. Output voltage is 15-30V. DC output will vary
according to the position of the Smart throttle switch.
1. Connect the charging cable to the DC receptacle of the generator and then to the
battery terminals.
■ To prevent the possibility of creating sparks near the battery,
connect the charging cable first to the generator then to the
battery. Disconnect the cable first at the battery.
■ Before connecting the charging cable to a battery that is
installed in a vehicle, disconnect the vehicle's battery
ground cable. Reconnect the vehicle's ground cable after
the charging cables are removed. This procedure will
prevent the possibility of a short circuit and sparks if
accidental contact is made between a battery terminal and
the vehicle's frame or body.
■ Do not attempt to start an automobile engine with the
generator still connected to battery. The generator may be
damaged.
■ Connect the positive battery terminal to the positive
charging cord. Do not reverse the charging cables or
serious damage to the generator and/or battery may occur.
■ The battery gives off explosive gases: keep sparks, flames
and cigarettes away. Provide adequate ventilation when
charging.
■ The battery contains sulfuric acid (electrolyte). Contact with
skin or eyes may cause severe burns. Wear protective
clothing and a face shield.
A. If electrolyte gets on your skin, flush with water.
B. If electrolytes gets in your eyes, flush with water for at
least 15 minutes and call a physician.
■ Electrolyte is poisonous.
If swallowed, drink large quantities of water or milk and
follow with milk of magnesia or vegetable oil and call a
physician.
■ Keep out of reach of children.
To Next Page
Loading...
