Kipor IG6000 - Page 16

14
Measure the spark plug gap and perform
the spark test.
Standard gap: .028-.034 in. (0.7-0.8 mm)
↓no spark
Perform the spark test again using a new
spark plug
→normal
spark
Replace the spark plug
↓no spark
Perform the spark test again using a new
ignitor
→normal
spark
Replace Ignitor
↓no spark
Disconnect low oil alarm and perform the
spark test.
→abnormal
Replace low oil alarm
↓no spark
Check the ignition control module
Replace the ignition module
↓normal
Check resistance of motor ignition winding
→abnormal
Replace the motor rotor
↓normal
Check trigger air gap and trigger
resistance
→abnormal
Adjust the air gap and/or replace the trigger
↓normal
Check the ignition coil resistance and high
voltage cable and insulation cap
→abnormal
Check the ignition coil
↓
Check or replace wiring harness
d. Engine oil level is low, but engine does not stop.
Drain out all engine oil, disconnect the
low oil alarm wire and check if the outlet
terminal is connected to ground
→not
conductive
Replace the oil level alarm switch
↓conductive
Connect the alarm wire, loosen ignition
module receptacle and check if the
orange wire is connected with the ground
→not
conductive
Repair or replace wiring harness
↓conductive
Replace ignition module
e. Engine speed does not increase or is unstable
Check air filter element for clog
clogged
Clean air filter element
↓not clogged
Check the valve clearance
→abnormal
Adjust the valve clearance
↓normal
Remove the spark plug and check the
electrodes for carbon and spark plug gap
→abnormal
Clean the spark plug and adjust the spark
plug gap or replace new spark plug