Kipor IG6000 - Page 17

15
↓normal
Check each carburetor hole and main
nozzle for blockage
→clogged
Disassemble and clean
↓not clogged
Check the air intake paper gasket and
the sealing of heat-insulation block of
carburetor
→abnormal
Tighten the nuts securely, replace the
gasket or heat-insulation block
↓normal
Test the cylinder compression
→abnormal
1. Check the valve clearance
2. Check combustion chamber for excess
carbon
3. Check the piston, piston ring and
cylinder for wear and damage.
↓normal
Perform the throttle control system
troubleshooting
f. Engine stops after starting (the smart throttle is in proper position)
Check the engine oil level and check if
oil level alarm activates when rotation
stops
→oil level
alarm
Add oil and restart the engine
↓sufficient oil
Check the fuel in fuel tank
→no fuel
Add fuel and restart the engine
↓sufficient fuel
Check for operation of fuel switch and
blockage in fuel filter
→clogged
Clean the fuel switch and filter
↓not clogged
Check for blockage of fuel hoses
→clogged
Clean or replace the hoses
↓not clogged
Turn the ignition switch to ON position,
check the timing relay for output
→ has
Replace the timing relay
Check each carburetor hole and main
nozzle for clogged
→clogged
Disassemble and clean
↓normal fuel flow
Check the intake gasket and the sealing
of carburetor heat-insulation block
→abnormal
Tighten the nuts securely, replace the
gasket or heat-insulation block
↓normal
Measure the cylinder compression →abnormal
1. Check the valve clearance
2. Check if too much carbon in burning
room
3. Check the piston, piston ring and
cylinder for wear and damage.