Kipor IG6000 - Page 18

16
↓normal
Check the trigger air gap
→abnormal
Readjust the clearance
↓normal
Perform throttle control system
troubleshooting
g. Throttle control system troubleshooting
1). Engine speed is too high or too low
Check AC output abnormal
Perform the generator troubleshooting
flowing the instruction of “No or Low AC
output”
↓normal
Check the stepping motor
→abnormal
Replace the stepping motor
↓normal
Replace the inverter unit
2). The engine speed does not increase when smart throttle is on and load is increased.
Check the AC output
→abnormal
Perform the generator troubleshooting
flowing the instruction of “No or Low AC
output”
↓normal
Check the stepping motor
→abnormal
Replace the stepping motor
↓normal
Check the smart throttle switch
→abnormal
Replace the smart throttle switch
↓normal
Check “Smart” switch connecting wire
→abnormal
Repair or replace the wire harness
↓normal
Replace the inverter unit
h. Low AC output
Is the overload indicator light ON?
→on
Disconnect the load, and restart the engine.
↓off
Is the engine speed normal?
Smart switch operation:
On: 2500±100rpm
Off: 3600±100rpm
→abnormal
Perform the throttle control system
troubleshooting
↓normal
Stop engine and check the AC receptacle
→abnormal
Replace the receptacle
↓normal
Check the AC output connector
→abnormal
Replace the connector
↓normal
Check voltage selector switch(only for
double voltage selector output)
→abnormal
Replace selector switch