picture 13
1.4 Disassemble fan gasket、fan impeller and fan seat
(1) Loosen the four M6×25 bolts, which fix fan impeller and fan gasket and then remove the fan
impeller and fan gasket.
(2) Loosen the three M6×16 bolts which fix fan seat and then remove the fan seat.
Refer to picture 14
picture 14
1.5 Disassembly the air conduct cover parts
(1) Loosen the three M10X20 bolts which fix the air conduct cover parts on the flywheel end.
(2) Loosen the four M6X16 bolts which fix the air conduct cover parts on the engine seat.
(3) Remove the air conduct cover parts
Refer to picture 15
picture 15
1.6 Disassemble the inlet pressurizer tank
(1) Loosen the four M6X18 bolts which fix the inlet pressurizer tank parts on the cylinder cover
To Next Page
Loading...
