Kirisun DM588 - Page 26

DM588 Service Manual
Item Environment
Measurement Tool and Method
Index Requirement
Test Device
Test Point
Tool
Method
8. TX distortion
After debugging the TX
modulation sensitivity,
1) Set the tester to TX
state, 300~3kHz to the
filter, and audio output to
1kHz@modulation
sensitivity;
2) Set the tester to
distortion meter (with
“Distn” displayed on the
screen);
3) Respectively set low,
medium and high TX
frequencies for a
channel, and then press
the PTT key.
General-purpose
tester
Connect
antenna
interface of the
radio to RF
IN/OUT interface
of the tester
* Observe the Distn value of the tester. <5%
23