9 10
4.3 Selecting a Channel
Turn the channel selector knob to your desired
channel. If voice annunciation has been set, the radio
will annunciate the current channel number. You will
hear voice from the speaker while receiving valid
signals.
4.4 Sending a Call
To make a call, press and hold the PTT button and
speak to the microphone in normal voice. Please
keep your mouth 3 - 8 cm away from the microphone.
M
I
C
4.5 Receiving a Call
Adjust the volume to a proper level. Release the PTT
button to receive a call.
5. Functions of Programmable
Buttons
Long Press Duration: Amount of time that the radio-
user is required to press (and hold down) a button, for
the press to be interpreted by the radio as a long
press. A short press is defined as any button-press
that is shorter than the duration.
The dealer can assign one of the following auxiliary
functions to the long press or short press of the
programmable button 1 and programmable button 2:
● None: No function is assigned.
● Monitor Momentary
Press and hold the preprogrammed Monitor
Momentary button to open squelch for monitoring the
tr an sm ission o n th e ch an ne l wh et he r th e
CTCSS/DCS, audio squelch conditions match or not.
Release it to exit monitor mode.
● Monitor
Press the preprogrammed Monitor button to open
squelch for monitoring the transmission on the
channel whether the CTCSS/DCS, audio squelch
conditions match or not. Press it again to exit monitor
mode.
● Squelch Off Momentary
Press and hold the preprogrammed Squelch Off
Momentary button to open squelch momentarily, and
release it to resume normal operation.
● Squelch Off
Press the preprogrammed Squelch Off button to open
squelch, and press it again to resume normal
operation.
● Channel Annunciation
Press the preprogrammed Channel Annunciation
button, the current channel number can be heard.
● Scan
Press the preprogrammed Scan button to start
scanning (the scan list should be effective), press it
To Next Page
Loading...
Need help?
General
