11 12
again during the scanning to stop scanning.
● High/Low Power Switch
Press the preprogrammed High/Low Power Switch
button to switch the current channel power between
high and low.
● Battery Check
Press the preprogrammed Battery Check button, the
current battery power level can be heard. There are
four levels in all. Level 4 indicates that the battery
power is full, and level 1 indicates that the battery
power is low.
● Squelch Adjust
Press the preprogrammed Squelch Adjust button to
change the current squelch level, and the squelch
level after the change can be heard.
● VOX
VOX function enables you to use the radio without
manual operations. This function can only be set by
the dealer, and you have to be equipped with the
specified earphones.
6. Scan Function
(this function can be disabled by the dealer)
If the scan function is enabled, you can press the
preprogrammed Scan button to start scanning and
press it again to stop scanning.
Explanations:
● After scan pauses, there are two ways to resume
scanning:
(1) Time operate: After pausing on an active channel,
the radio will resume scanning after a preprogrammed
delay. The scan delay time can be preset from 0.5 to
5 seconds.
(2) Carrier operate: After pausing on an active
channel, the radio will resume scanning after a
preprogrammed delay after the channel becomes
inactive. The scan delay time can be preset from 0.5
to 5 seconds.
● The revert channel during scan can be designated
through PC software. There are following options
available:
(1) Last Rx channel:
When pressing the PTT button during scanning, the
radio will transmit from the last channel that received
a call.
(2) Designated Tx channel:
When pressing the PTT button during scanning, the
radio will transmit from the selected channel.
(3) Priority channel (the priority channel must be set)
When pressing the PTT button during scanning, the
radio will transmit from the priority channel in the scan
list.
(4) Last Tx channel:
When pressing the PTT button during scanning, the
radio will transmit from the last channel that transmits
signals.
(5) Selected channel:
When pressing the PTT button during scanning, the
radio will transmit from the channel selected by the
channel selector knob.
Before using VOX, you must set VOX gain level.
Such setting enables the radio to identify the voice
volume. If the microphone is too sensitive, the
background noise will trigger the radio to transmit. If
the microphone is not sensitive enough, it cannot
receive your voice when you speak. Make sure to
adjust the VOX gain level to proper sensitivity.
To Next Page
Loading...
Need help?
General
