Removing And Replacing
An Oven Door
Both oven doors can be removed to
change optional oven door fronts.
Do not remove them for cleaning.
Personal Injury Hazard
• Oven doors are heavy. Use
both hands to remove the
oven doors.
• Grasp only the sides of the
oven door, Do not use
any portion of the front frame
or trim for lifting,
Failure to properly grasp the
oven door could result in
personal injury or product
damage,
Screw
To remove:
1. Open door completely.
2. Remove the two screws just above
the oven door hinges.
3. Close door to the broil stop
position (door will be open about
6 inches).
4. Hold the door firmly on both sides
and lift the door up and out of
the hinge slots to remove. Set the
door aside.
To replace:
1. Grasp door firmly on both sides.
Slide the hinge slot in the bottom of
the door over the hinges. Push the
door down and in to replace.
2. Open the door slightly past the
broil stop position and push it
down to make sure the door is
completely installed.
3. Open the door completely. Replace
the two oven door screws.
4. Close and open the door slowly to
make sure it is replaced properly.
Optional Oven Door
Fronts
The front door glass can be changed
to match your kitchen decor. The
following front kits are available from
your KitchenAid dealer: White Glass
(Kit No. 3177770), and Almond Glass
(Kit No. 3177772). Two kits are
required for a double oven. These kits
include easy installation instructions.
29