3.2 Safety instructions
3.2.1 Before use
ALWAYS allow the instructed (trained in safety and operation) people to operate the hoist.
ALWAYS check the hoist before daily use according to the "Daily inspection" (Refer to 7.3.2).
ALWAYS make sure that the chain length is long enough for the intended work.
ALWAYS check that the hook latches work properly and replace missing or broken hook latches
(Refer to 7.3).
ALWAYS check the brake before use (Refer to 7.3).
ALWAYS use two hoists which each has Capacity equal to or more than the load to be lifted
whenever you must use two hoists to lift a load.
ALWAYS use KITO original chains or authorized chains.
ALWAYS check and keep the surface of the load chain oiled.
NEVER use a hoist without a hoist name plate.
NEVER use a modified or deformed hook.
NEVER use a hoist in explosive atmosphere.
3.2.2 While operation
ALWAYS make sure that the load is properly seated in the hook.
ALWAYS tighten the slack out of the chain and sling when starting a lift to prevent a sudden
loading.
ALWAYS avoid excessive inching operation.
ALWAYS make sure the hoist motor completely stops before reversing.
ALWAYS use a hoist within the "Duty rating", ED% or time rating.
NEVER operate unless the load is centered under the hoist.
NEVER use the hoist chain as a sling.
NEVER use a twisted. kinked, damaged or stretched load chain.
NEVER swing a suspended load.
− 2 −
To Next Page
Loading...
Need help?
General
