What to do if KKT Chiller pump 1 motor protection has triggered?
If the pump 1 motor protection has triggered, it could be due to the motor current being outside the permitted range or the pump being blocked. Check pump 1 for a short-circuit in the supply cable, an internal short-circuit in the motor windings, or if the motor is blocked. Also, verify if the load contactor is working correctly.
What to do if the KKT Chiller pump 1 flow is insufficient?
If pump 1 flow is insufficient, it may be due to high pressure loss. Check the external piping for closed gate valves, a blocked water filter, or system leaks.
What to do if AI high pressure sensor breaks in KKT Chiller?
If there is a sensor break with the AI high pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI low pressure sensor breaks in KKT Chiller?
If there is a sensor break with the AI low pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI inlet temperature sensor breaks in KKT Compact-Line cBoxX 120?
If there is a sensor break with the AI inlet temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI outlet temperature sensor breaks in KKT Compact-Line cBoxX 120 Chiller?
If there is a sensor break with the AI outlet temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI tank pressure sensor breaks in KKT Compact-Line cBoxX 120?
If there is a sensor break with the AI tank pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI water inlet pressure sensor breaks in KKT Compact-Line cBoxX 120 Chiller?
If there is a sensor break with the AI water inlet pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI ambient temperature sensor breaks in KKT Compact-Line cBoxX 120 Chiller?
If there is a sensor break with the AI ambient temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI suction vapour temperature sensor breaks in KKT Chiller?
If there is a sensor break with the AI suction vapour temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
Details product description, intended use, technical data, and key components.
Explains the function and working principle of the compressor.
Describes the evaporator's role in heat transfer with the cold water.
Details the condenser's function in transferring heat to ambient air.
Covers general safety, hazard warnings, symbols, and definitions.
Details residual energy, safety devices, pressure/flow monitoring, and PPE.
Outlines installation tasks and requirements for the installation site.
Covers hydraulic connections, frost protection, filling, venting, and electrical installation.
Provides a checklist to ensure all installation steps are complete before startup.
Details control panel elements, navigation, and menu structures.
Explains controller functions, parameters, levels, and operating modes.
Covers maintenance importance, fault correction references, and service contact.
General| Tank volume | 3.5 l |
|---|---|
| Refrigerant | R134a |
| Operating Temperature Range | +5°C to +35°C |
| Cooling capacity | 1200 W |
| Power Supply | 230 V / 50 Hz |
| Dimensions (LxWxH) | 1200 x 800 x 1600 mm |
| Temperature stability | ±0.1 K |
To Next Page