What to do if KKT Compact-Line cBoxX 80 pump 1 motor protection has triggered?
If the pump 1 motor protection has triggered, it could be due to the motor current being outside the permitted range or the pump being blocked. Check pump 1 for a short-circuit in the supply cable, an internal short-circuit in the motor windings, or if the motor is blocked. Also, verify if the load contactor is working correctly.
What to do if the KKT Chiller pump 1 flow is insufficient?
If pump 1 flow is insufficient, it may be due to high pressure loss. Check the external piping for closed gate valves, a blocked water filter, or system leaks.
What to do if AI high pressure sensor breaks in KKT Chiller?
If there is a sensor break with the AI high pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI low pressure sensor breaks in KKT Chiller?
If there is a sensor break with the AI low pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI inlet temperature sensor breaks in KKT Compact-Line cBoxX 80?
If there is a sensor break with the AI inlet temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI outlet temperature sensor breaks in KKT Chiller?
If there is a sensor break with the AI outlet temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI tank pressure sensor breaks in KKT Compact-Line cBoxX 80?
If there is a sensor break with the AI tank pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI water inlet pressure sensor breaks in KKT Compact-Line cBoxX 80 Chiller?
If there is a sensor break with the AI water inlet pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI ambient temperature sensor breaks in KKT Compact-Line cBoxX 80 Chiller?
If there is a sensor break with the AI ambient temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI suction vapour temperature sensor breaks in KKT Chiller?
If there is a sensor break with the AI suction vapour temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
Explains the role and type of the compressor.
Describes heat transfer from cold water to refrigerant.
Details heat transfer from refrigerant to ambient air.
Manages operations and visualizes system data.
Ensures the necessary circulation of the cold water.
Identifies potential dangers and necessary precautions.
Explains the meaning of safety icons used in the manual.
Discusses potential hazards from stored energy.
Details protective mechanisms like pressure limiters and monitors.
Specifies required PPE for operation and servicing.
Methods and precautions for moving the unit.
Requirements for the chiller's installation location.
Specifies required space around the unit for air supply and service.
Requirements for the base and foundation of the installation.
Guidelines for connecting the water circuits.
Methods to prevent freezing in the cold water circuit.
Procedures for filling the chiller with operating fluid.
Procedure for removing air from the pump.
Instructions for wiring the chiller to the power supply.
A checklist of tasks to complete before commissioning.
Regulates the cold water temperature based on sensor feedback.
Manages the operation of the compressors.
Importance and overview of regular maintenance.
Guidance for troubleshooting and correcting issues.
General| Cooling capacity | 0.8 kW |
|---|---|
| Refrigerant | R134a |
| Power Supply | 50 Hz |
| Ambient Temperature Range | 10 - 40 °C |
| Water Flow Rate | 80 l/min |
| Water Pressure Drop | 2.0 bar |
To Next Page