What to do if KKT Compact-Line cBoxX 50 pump 1 motor protection has triggered?
If the pump 1 motor protection has triggered, it could be due to the motor current being outside the permitted range or the pump being blocked. Check pump 1 for a short-circuit in the supply cable, an internal short-circuit in the motor windings, or if the motor is blocked. Also, verify if the load contactor is working correctly.
What to do if the KKT Compact-Line cBoxX 50 Chiller pump 1 flow is insufficient?
If pump 1 flow is insufficient, it may be due to high pressure loss. Check the external piping for closed gate valves, a blocked water filter, or system leaks.
What to do if AI high pressure sensor breaks in KKT Compact-Line cBoxX 50?
If there is a sensor break with the AI high pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI low pressure sensor breaks in KKT Chiller?
If there is a sensor break with the AI low pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI inlet temperature sensor breaks in KKT Chiller?
If there is a sensor break with the AI inlet temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI outlet temperature sensor breaks in KKT Chiller?
If there is a sensor break with the AI outlet temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI tank pressure sensor breaks in KKT Chiller?
If there is a sensor break with the AI tank pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI water inlet pressure sensor breaks in KKT Compact-Line cBoxX 50 Chiller?
If there is a sensor break with the AI water inlet pressure in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI ambient temperature sensor breaks in KKT Compact-Line cBoxX 50 Chiller?
If there is a sensor break with the AI ambient temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
What to do if AI suction vapour temperature sensor breaks in KKT Chiller?
If there is a sensor break with the AI suction vapour temperature in your KKT Chiller, you should test the supply cable, connector, and sensor.
Explains the function of major components like compressor, evaporator, condenser, expansion valve, and refrigerant.
Details sensors, control unit, display, and control cabinet for system operation and monitoring.
Describes the pump, fan, cold water cycle, and materials used in the water circuit.
Specifies the required water quality limits and permitted cooling media for the chiller.
Provides general safety instructions, definitions of safety symbols, and hazard warning types.
Addresses risks from residual energy, chemicals, misuse, and details safety devices and monitoring.
Lists common faults, their descriptions, causes, and recommended correction measures.
General| Refrigerant | R134a |
|---|---|
| Power Supply | 230 V / 50 Hz |
| Temperature stability | ±0.1 K |
| Tank volume | 15 liters |
| Operating Temperature Range | 35 °C |
To Next Page