Klafs 16029 - Page 18

SaunaP UR
PAGE 18
5070178/07.02
7. Troubleshooting
7.2. Further possible faults
Error Cause Remedial action
The control unit will
not switch on.
No mains voltage. Check the FI switch and fuse in the power
supply.
Display:
Fault message 91.
The touch-sensitive safety
switch (SKS) above the
heater has triggered.
Check in the cabin whether there is anything
on top of the heater. If so, remove the
object.
Check whether the grille is loose. If so,
reinsert the grille.
The cabin light is not
illuminated after
switching on.
Lamp defective. Change lamp.
1. Disconnect the control unit from the
mains.
2. Insert lamp with the same power rating.
No mains voltage. Check the FI switch and the fuse in the
power supply.
Fuse SI100 has triggered. ReplacefuseSI100(1.25AT)orinformthe
Klafs Service.
The control unit
cannot be started or
operated.
Additional option (PC)
appears in the display.
The control unit is controlled
b
y
K
l
a
f
s
o
n
t
r
o
l
Switch off Klafs Control.
. After approx. 5 minutes, Klafs Control
releases the control unit.
b
y
K
l
a
f
s
C
o
n
t
r
o
l
.
The operating panel is
blocked.
Disconnect the data line between Klafs
Control and the control unit.
The heater will not
heat up (when
controlled via Klafs
Control or building
process control GLT).
Additional option (key)
appears in the display for
30 minutes.
The load release of the sauna
cabin heater is requested via
Klafs Control or GLT.
Remove combustible objects from the
heater!
Actuate the key switch on the sauna cabin
for 1 second within 30 minutes after start at
Klafs Control or GLT.
Additional option (key)
does not appear in the
display.
The load release of the cabin
heater is not requested via
Klafs Control or GLT.
The30minutewaitingperiod
has expired.
Request the load release of the sauna cabin
heater via Klafs Control or GLT.
Remove combustible objects from the
heater!
Actuate the key switch on the sauna cabin
for 1 second within 30 minutes after start at
Klafs Control or GLT.