36
EN
Activated carbon lter
Activated carbon lters can be used to remove odours. Normally, the activated charcoal
lter should be changed after three or six months, depending on your cooking habits.
The installation of the activated carbon lter is done as follows:
1 Disconnect the extractor bonnet from the power supply before installation.
2 Press the lter lock and remove the mains lter.
3 Rotate the carbon lter counter-clockwise on both sides of the motor. Replace the
old carbon lters with new carbon lters.
4 Replace the mains lter.
5 Reconnect the power cord to the power socket.
Note: Make sure that the lter is tightly closed. It can otherwise detach and become
dangerous. If an activated carbon lter is connected, the suction power is reduced.
open
close
To Next Page
Loading...
