31
EN
NOTES FOR THE INSTALLATION OF THE
EXHAUST AIR PIPE
The following rules must be strictly observed to achieve optimum air extraction:
• Make sure that the exhaust pipe extends as short and straight as possible.
• Do not reduce the size or restrict the exhaust pipe.
When using exhaust air pipes, always install the pipe tightly to minimise pressure
loss.
• Non-compliance with these basic instructions will reduce the performance and
increase the noise level of the cooker bonnet.
• All installation work must be carried out by an electrician or a quali ed person.
• Do not connect the exhaust pipe of the bonnet to an existing ventilation system used
for another appliance, e.g. a ue, gas pipes or hot air pipes.
• In case the exhaust air pipe is bent, the angle of the exhaust air pipe should not
be less than 120°. Never point the exhaust air pipe downwards, but always
horizontally or guide the pipe from the starting point upwards to the air outlet on the
outside wall.
• After installation, please make sure that the cooker bonnet is positioned horizontally
to prevent grease from accumulating.
• Make sure that the exhaust pipe selected for installation complies with the relevant
standards and is re-retardant.
CAUTION
Risk of injury! For safety reasons, only use the size of fastening or
mounting screw recommended in these operating instructions.
Non-compliance with these instructions can lead to injuries and electric
shocks.
To Next Page
Loading...
