Klein Tools CL380 User Manual

12
ENGLISH
Red leadBlack lead
CONTINUITY
1. Insert RED test lead into VΩ jack
5
, and BLACK test lead into
COM jack
4
, and rotate function selector switch
2
to the
Continuity/Resistance/Capacitance/Diode-Test
setting.
NOTE: The meter defaults to Continuity testing in this mode. Ensure
that the Continuity Testing icon
is visible on the display. If not,
press the "SEL/NCV" button
12
repeatedly until the icon is
shown.
2. Remove power from circuit.
3. Test for continuity by connecting conductor or circuit with test
leads. If resistance is measured less than 10Ω, an audible signal
will sound and display will show a resistance value indicating
continuity. If circuit is open display will show "OL".
DO NOT attempt to measure continuity on a live circuit.
OPERATING INSTRUCTIONS

Klein Tools CL380 Specifications

General

Type	Clamp Meter
Continuity	Yes
Battery	2 x AAA
Auto Power Off	Yes
Safety Rating	CAT III 600V
Display	LCD
Measurement Functions	Voltage, Current, Resistance, Capacitance, Frequency
AC Voltage Range	0.1 to 600V
DC Voltage Range	0.1V to 600V
Resistance Range	0.1 to 40MΩ
Frequency Range	10Hz to 1kHz
Operating Temperature	32°F to 104°F (0°C to 40°C)