KLIM 10U - Bluetooth Device Pairing; Mobile Phone & Stereo Pairing

10U
14
5 PAIRING THE 10U WITH BLUETOOTH
DEVICES
Before using the 10U Bluetooth headset with any other Bluetooth
devices for the rst time, you will need to pair them together. You can
pair the 10U with Bluetooth mobile phones, Bluetooth stereo devices
such as MP3 players, or motorcycle specic Bluetooth GPS navigation,
and with other Sena Bluetooth headsets. The pairing operation is
required only once for each Bluetooth device. The headset remains
paired with the devices and automatically reconnects to them when
they are within range. You will hear a high toned single beep and a
voice prompt whenever the headset reconnects to the paired device:
“Phone connected” to a mobile phone, “Media connected” to a
Bluetooth stereo device.
5.1 Mobile Phone Pairing - Mobile Phone, Bluetooth
Stereo Device
1. Press and hold the Center Button for 10 seconds until you hear
the voice prompt, “Conguration menu”.
2. Tap the (+) Button until you hear a voice prompt, “Phone pairing”.
3. Search for Bluetooth devices on your mobile phone. Select the
10U in the list of the devices detected on the mobile phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the
PIN.
5. The mobile phone conrms that pairing has completed and the
10U is ready to use. You will hear a voice prompt, “Your headset
is paired”.
6. If the pairing process is not completed within three minutes, the
10U will return to stand-by mode.
Note:
1. If a Bluetooth connection between the headset and a mobile phone is
disconnected, press the Center Button for 3 seconds until you hear a
high tone single beep to recover the Bluetooth connection immediately.
2. If the Bluetooth connection between the headset and a media player is
disconnected, press the Center Button for 1 second to recover the
Bluetooth connection and play.