10U
35
English
Note:
1. You can save FM stations to presets before using FM radio. Connect the
10U to your PC and open the Sena Device Manager. It allows you to save
up to 10 FM station frequency presets on the 10U settings menu. You
may do the same operation by using the Sena Smartphone App.
2. You can still answer an incoming phone call and intercom while listening
to the FM radio.
12.4 Scan and Save
“Scan” is the function that automatically searches station frequencies,
starting from the current frequency and up. To use the scan function,
please follow the procedures below:
1. Press the (+) Button for 1 second. Then the current station
frequency moves upward to nd other station frequencies.
2. If the tuner nds a station, it stays at the station frequency for 8
seconds, then scanning to the next station frequency.
3. Scan function stops when you press the (+) Button for 1 second
again.
4. To save a station while scanning frequencies, tap the Center
Button when at that station. You will hear a voice prompt from
the 10U, “Save preset (#)”. The station will be saved as the next
preset number.
5. All stations preset during “Scan”, will overwrite previously set
stations.
12.5 Temporary Preset
With the temporary preset function, you may temporarily preset
stations automatically without changing the existing preset stations.
Tap the (+) Button three times to automatically scan for 10 temporary
preset stations. The temporary preset stations will be cleared when the
system is powered off.
To Next Page
Loading...
