KLIM 10U - Setting Intercom Vox Sensitivity; Enabling;Disabling Voice Prompts; Enabling;Disabling RDS AF

10U
42
14.10 Setting Intercom Vox Sensitivity
Voice Prompt
“VOX sensitivity”
Factory Default 3
Level Adjustment
Tap the (+) Button or the (-) Button
(1 ~ 5)
Apply Tap the Center Button
Tap the (+) Button or the (-) Button until you hear the voice prompt,
“VOX sensitivity”. By tapping the Center Button, it will lead you to the
level adjustment mode. If you enter the mode, you will hear a prompt
stating the current VOX sensitivity level. You may adjust the VOX
sensitivity level by tapping the (+) Button or the (-) Button. Level 5 is
the highest sensitivity setting and 1 is the lowest. After you have
completed the setting, tap the Center Button to apply the changes.
14.11 Enabling/Disabling Voice Prompts
Voice Prompt
“Voice prompt”
Factory Default Enable
Enable/Disable Tap the Center Button
You can disable voice prompts by conguration setting, but the
following voice prompts are always on.
– Voice prompts for conguration setting menu
– Voice prompts for battery level indicator
– Voice prompts for speed dial
– Voice prompts for FM radio functions
14.12 Enabling/Disabling RDS AF
Voice Prompt
“RDS AF setting”
Factory Default Enable
Enable/Disable Tap the Center Button
RDS AF allows a receiver to re-tune to the second frequency location
when the rst signal becomes too weak. With RDS AF enabled on the
receiver, a radio station with more than one frequency can be used.