KLIM 10U - Selective Profile Pairing

10U
16
5.3 Advanced Selective Pairing - A2DP Stereo or
Handsfree
When you are using a smartphone, sometimes you may need to
selectively use the 10U for A2DP stereo music only or for mobile phone
handsfree only. These instructions are for advanced users who want to
pair the 10U to their smartphones with only one selective prole: A2DP
for stereo music of HFP for phone calls.
If you have previously paired a mobile phone to the 10U, you must
clear the previous pairing list on both devices: the mobile phone and
the 10U. To clear the pairing list on the 10U, please do a factory reset
or following the pairing list clearing procedure described in
section
14.18, “Factory Reset” or 14.15, “Delete All Bluetooth Pairing
Information” . To clear the pairing list on the mobile phone, please refer
to the mobile phone manual. For most smartphones, delete the 10U
from the list of Bluetooth devices in the settings menu.
5.3.1 A2DP Stereo Music Only
1. To enter the voice conguration menu, press and hold the
Center Button for 10 seconds until you hear the voice prompt,
“Conguration menu”.
2. Tap the (+) Button until you hear the voice prompt, “Media
selective pairing”.
3. Search for Bluetooth devices on your smartphone. Select the 10U
in the list of devices detected on your phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the
PIN.
5.3.2 HFP for Phone Call Only
1. To enter the voice conguration menu, press and hold the
Center Button for 10 seconds until you hear the voice prompt,
“Conguration menu”.
2. Tap the (+) Button until you hear the voice prompt, “Phone
selective pairing”.
3. Search for Bluetooth devices on your smartphone. Select the 10U
in the list of devices detected on your phone.
4. Enter 0000 for the PIN. Some mobile phones may not ask for the
PIN.