10U
48
17 TROUBLESHOOTING
17.1 Intercom Failure
When you try to start an intercom conversation with an intercom friend
who is unavailable within range or already having a conference
intercom with other riders or a mobile phone call, you will hear a low
tone double beep signifying an intercom busy signal. In this case, you
have to try again later.
17.2 Intercom Reconnection
If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom
will be disconnected. In this case, the 10U automatically tries to
reconnect the intercom every 8 seconds and you will hear high tone
double beeps until the intercom is reestablished. If you do not want to
make a reconnection, tap the Center Button to stop the attempt.
17.3 Fault Reset
When the 10U is not working properly or is in faulty status for any
reason, you may reset by pushing the pin-hole reset button as shown
in the picture below. Insert a paper clip into the reset pin-hole and
press the reset button for a second with light pressure. The 10U will be
switched off. Restart the system and try again. This will not restore the
headset to factory default settings.
17.4 Factory Reset
If you want to restore the headset to factory default settings, use the
Factory Reset in the conguration menu. The headset automatically
restores the default settings and turns off. Please refer to
section
14.18, “Factory Reset”
for more details.
To Next Page
Loading...
