klover ECOMPACT 290 - Troubleshooting and Alarms; Problem Diagnosis (What Happens If...)

31
PELLET-BURNING BOILER ECOMPACT 150-190-250-290
EN - Rev 1.1
- “Menu 01 – Select season = SUMMER” the appliance will immediately go into stand-by “STOP FLAME”.
- “Menu 01 – Select season = WINTER” the motorised three-way valve and the appliance will go into stand-by “STOP
FLAME” only if the conditions in the heating system are satisfied.
- Buffer temperature
For system type 4, to modify the buffer temperature, simply select “SET BUFFER” by pressing buttons 1 or 2. Now use
buttons 1 and 2. During this operation, the display will appear as in the following picture.
Set
1
2
3
6
5
4
After setting the desired value, press button 4 or wait a few seconds.
During the working phase the appliance will switch to “Economy mode” if T.H2O > SET BUFFER + 10°C.
It will go into stand-by “STOP FLAME” only if the “SET BUFFER” temperature is reached.
PROBLEMS, ALARMS, USEFUL ADVICES
Useful info…
Listed below is some important information regarding the appliance:
- It is normal for the appliance to emit a smell of paint during its first few days of operation. We recommend ventilating
the installation room during the initial start-up. For the first few days of operation we also recommend that you set the
appliance to near-maximum level.
- The boiler unit is treated with anti-oxidant paint in order to protect it against oxidation in the event of long periods of
inactivity. After initial start-up, this paint no longer preserves its original features and any wear of the paint inside the
combustion chamber should not be regarded as a manufacturing fault.
- Do not clean with water inside the combustion chamber; any oxidation of the combustion chamber after a long period
of inactivity is not to be considered as a manufacturing fault.
- Any perceived noise during operation may be caused by the expansion settling of the plates that make up the boiler
unit. These noises are accentuated especially during ignition and switching off phases of the appliance and are not to
be considered a manufacturing fault.
- If ignition fails, empty the pellets out of the brazier; only then can you reignite the appliance in order to avoid
gasification and consequent “explosion” during ignition which could lead to the breakage of the door glass.
- The appliance works exclusively with wooden pellets; do not burn different fuels.
- The appliance can work only if connected to the heating system and with water inside the boiler unit. Do not start the
appliance for any reason if a plumbing connection in compliance with current regulations has not been done and if
you have not filled the entire boiler unit and system with water in order not to compromise its life.
- The noise heard during the ignition stage is due to the automatic cleaning of the turbulators.
- The noise level of the appliance is emphasised if the pellet container is empty. Therefore we recommend that you
always keep the pellet level to at least half tank.
- If there is soot and fine particulate in the room where the appliance is installed, check the seal on the flue gas pipes
and the filter of the ash vacuum device used for cleaning.
- In the event of overheating, the appliance will switch off when it reaches 85°C.
What happens if…
…the pellets do not ignite
If the ignition fails, the display will show the alarm message “NO IGNITION”.
Cancel the alarm and reset the appliance to standard condition by pressing button 4 for a few seconds.
65°
C
SET BUFFER