KMC Controls BAC-19 FlexStat Series - Page 10

BAC-19xxxx FlexStat Application Guide 10 AG200824A
Setpoint Options
System
Conguration
Options
Setpoint
Conguration
Options
Enable/Disable System
and Communications
Menus on the Display
Setpoints Tab
Advanced Tab
Options Tab
NOTE: See Settings on page 3 for explanations of options. After saving changes, restart the FlexStat.
NOTE: One setpoint
can be
disabled if
the FlexStat
is used for
only cooling
or only
heating.
NOTE: If disabled, system
or communication
options can then
only be changed in
software.