Do you have a question about the KMC Controls FlexStat BAC-120063CW-ZEC and is the answer not in the manual?
Model | BAC-120063CW-ZEC |
---|---|
Input Voltage | 24 VAC |
Temperature Range | 32°F to 122°F (0°C to 50°C) |
Operating Temperature | 32°F to 122°F (0°C to 50°C) |
Communication Protocol | BACnet MS/TP |
Display | LCD |
Enclosure Rating | NEMA 1 |
Controller Type | FlexStat |
Outputs Type | 2 Analog |
Details on how to physically install the FlexStat unit to a wall, including wiring and cover attachment.
Diagram and explanation for connecting a FlexStat to a Roof Top Unit (RTU) controller.
Diagram and explanation for connecting a FlexStat to a Zone 1 controller.
Diagram and explanation for connecting a FlexStat to a Zone 16 controller.
Details on connecting input sensors and signals to the RTU controller.
Details on connecting output actuators and devices to the RTU controller.
Details on connecting input sensors and signals to the HPU controller.
Details on connecting output actuators and devices to the HPU controller.
Essential advice on planning conduit, wire sizing, and using multiple conductors for connections.
Details on connecting devices to the FlexStat's output terminals.
Details on connecting passive and active input devices to the FlexStat.
Instructions for connecting the FlexStat to an MS/TP network using three-conductor cable.
Configuration of input pull-up switches for thermistors and voltage devices.
Setting the End-Of-Line termination switches for MS/TP network operation.
Steps to select the application, configure settings, and set the device address.
Setting the BACnet Device Instance and MS/TP MAC address for network communication.
Adjusting heating and cooling DAT setpoints and duct static pressure setpoint.
Modifying the factory default schedule for occupied and unoccupied times.
Overview of preconfigured trend logs for monitoring system data.
Displaying connected zone status, calls for heating/cooling, and duct status pressure.
Explanation of how the FlexStat determines RTU/HPU heating or cooling mode by majority rule.
Instructions for cleaning the FlexStat unit, including dust removal and display cleaning.
Methods for customizing FlexStat functionality using KMC software and programming.
Using the BAC-5051E router for remote monitoring and configuration of the zoning system.
References to other documents and web pages for more detailed information on the FlexStat and related products.
Disclaimers regarding document content, product changes, and FCC compliance.