80
Connecting to your Printer
1. Make sure both the camera and printer are turned on.
2. Connect one end of the supplied USB cable to the
USB port on your camera.
3. Connect the other end of the cable to the USB port on
the printer.
If the camera is not connected to a PictBridge compatible
printer, the following error message will appear on the
LCD.
The error message above will also appear if the
USB mode is set incorrectly, in which case you
should disconnect the USB cable, check the USB
mode settings, ensure that the printer is turned on,
and then try connecting the USB cable again.
To Next Page
Loading...
