6
SETTING
UP
HANDLE
A self-storing spring-loaded
HANDLE
provides
an
easy
way
to carry your
projector. For carrying, simply raise the handle
as
far
as
it
will
go
;
for
storage, push the handle down.
POWER
CORD
The POWER CORD is permanently attached to your projector and is stored
on
the CORD RETAINER
on
the bottom
of
the projector.
To
unwind the cord ,
place the projector
on
its side.
Your
CAR
OUSEL
Projector
operates
on
120-volt,
60
Hz
power
only. Plug
the power cord into a suitable electrical outlet.
(If
you plug your pro-
jector into a different electrical source, the projector
can
be
damaged.)
REMOTE·CONTROL
CORD
The 12-foot REMOTE-
CONTROL
CORD
is
stored
in
the CORD
COMPARTMENT
at
the
front
of
the projector. Push down the door latch to open the door.
Plug the remote-control cord into the remote-control socket at the
rear
of
the projector. The small dot should
be
upward when the plug
is
in the socket.
To Next Page
Loading...
Need help?
General