LENS
COVER
A sliding LENS COV
ER
protects the projection lens when you carry or store
your projector. Slide the cover toward the cord-storage door to uncover
the lens. (Remove the remote-control cord first, since the cover slides
over the cord compartment.)
If your projector is equipped with the
optional zoom lens, remove the lens to close the lens cover.
DUST
COVER
An
attractive transparent dust cover is supplied with your projec
tor
to
protect it from dust and
dirt.
To
install the cover, position
it
on
top
of
the projector; then slide the
spring-loaded
DUST-COVER LATCH toward the rear
of
the projector until
the cover drops
in
to place.
To
remove the cover, push the latch toward
the rear of the projector and
lift
off the cover. (You must remove the
cover to
use
the projector.)
SCREEN
AND
SEATS
Because slides may
be
square, horizontal,
or
vertical in format, a square
screen is usually most convenient. It should
be
large enough
for
easy
viewing
by
everyone present. If possible, your projector should
be
at the
same level
as
the center
of
the screen.
For easy viewing, your audience should not
be
farther
from the screen
than 6 times the longer dimension
of
the projected image.
See
the
chart listing projector-to-screen distances
on
the next page. Place the
seats
as
close
as
possible to both sides of the beam thrown
by
the
projector. The picture appears most
brilliant
and lifelike when you are
seated near the projected beam.
7
To Next Page
Loading...
