A-61679 May 2015 41
Device - General tab The General tab allows you to set scanner-specific options and
provides access to scanner diagnostics.
Paper Source
• Automatic: looks for paper in the document feeder first. If there are
no documents in the input tray, the scanner will scan from the flatbed.
• Document Feeder: the scanner will only scan documents from the
input tray.
• Flatbed: scanner will scan from the flatbed.
NOTE: Automatic and Flatbed options are only available if you had
the flatbed accessory attached when the scanning application
connected to the scanner.
Power Saver — allows you to set the amount of time, in minutes, the
scanner has to be inactive before going into power saver mode.
Power Off — allows you to set the amount of time, in minutes, the
scanner has to be in power saver mode before it automatically turns off.
NOTE: The Power Saver setting is shared with all Setting Shortcuts.
Any changes will affect other shortcuts unless you turn on the
Only save to this Setting Shortcut option.
To Next Page
Loading...
