36 A-61679 May 2015
Creating different
settings for each side of
a document, Example 3
In this example, let’s assume you want to configure a two-sided
document stream of business documents that have color on the front of
the document but the rear side is fine in black and white.
NOTE: This example is only available for duplex scanners.
1. If you are not already on the Advanced tab:
• Select a Setting Shortcut from the main Scanner window that
closely describes your desired output.
•Select Settings to display the Image Settings window.
• Select the Advanced Image Setup icon on the Image Settings
window to display the Advanced tab.
2. Select Input document is: Two Sided.
3. Turn on the Different settings per side option.
4. Select Images per side: One.
5. Select Done to return to the Image Settings window.
NOTE: You will notice that the Side option now has two entries:
Front and Back.
6. Select Side: Front.
7. Select Color (24-bit) for the Scan as option on the General tab.
NOTE: Make any other adjustments to the front side settings on
the rest of the tabs on the Image Settings window.
8. Select Side: Back.
9. Select Black and White (1-bit) for the Scan as option on the
General tab.
NOTE: Make any other adjustments to the back side settings on
the rest of the tabs on the Image Settings window.
10.When finished, select Home to return to the main Scanner window
and then select Save to save your selections to the shortcut.
To Next Page
Loading...
