A-61778 December 2013 3-1
3 Scanner Adjustments
Contents Adjusting the input/output tray ...................................................................3-1
Flatbed scanning........................................................................................3-3
Using the rear document exit.....................................................................3-5
Selecting your scanning application ..........................................................3-6
Adjusting the input/
output tray
You can adjust the input and output trays to accommodate your scanning
needs.
• Adjusting the side guides — the side guides can be moved in or out to
accommodate document size. When adjusting the side guides, place your
hands on the bottom of the side guides, over the slots in the tray to easily
slide the guides in and out.
• Adjusting the input tray for document length — the input tray extender
has two positions.
- Document lengths up to 11 inches /27.9 cm — pull the extender out to
the first position.
- Document lengths from 11 to 17 inches / 27.9 to 43.2 cm — pull the
extender out to the full position.
- Document lengths more than 14 inches / 35.6 cm — if you are
scanning documents longer than 17 inches / 43.2 cm, the scanner driver
must be set to accommodate these long documents. Be sure to verify that
the Maximum Length option on the Device-General tab (TWAIN
Datasource) or the Longest Document option on the Scanner tab (ISIS
Driver) is set to longer than the longest document being scanned.
NOTE: Operator assistance may be required for scanning documents
greater than 17 inches / 43.2 cm.
To Next Page
Loading...
