2
Safe operation
Pay attention to all safety messages and follow all procedures for
operating the platesetter and for solving problems, and ensure that this
safety guide is accessible to anyone who operates the platesetter.
The safety messages and procedures are in the user guide (available
through the Help menu in the device control software) and in the visual
reference guide.
Keep panels closed during operation
During normal operation (media loading, exposing, and unloading), all
panels must be closed and locked to reduce the risk of exposure to laser
radiation or moving parts.
When resolving a problem, you may be instructed to open the rear
hood and remove the rear panel in order to perform the following
actions:
●
Remove media that is stuck or has come off the drum
●
Reposition the trailing-edge clamps on the drum—that is, put them
in the park position
To safely open the rear hood and remove the rear panel, follow the
instructions in the visual reference guide or the user guide.
Figure 9: Rear hood on a Magnus VLF semiautomatic platesetter
To Next Page
Loading...
Need help?
General
