3
Safe maintenance
The maintenance tasks that operators can safely perform are described
in the user guide (available through the Help menu in the device control
software) and in the visual reference guide.
Operators can safely perform the following maintenance tasks:
●
Cleaning exterior surfaces, including the area where media enters
the platesetter
●
Cleaning the edge detection strip
●
Cleaning the plate roller
●
Cleaning cassettes (platesetters with one or more cassettes)
●
Replacing the compressed air supply particulate filter on the
platesetter, and, if equipped with optional APL, both compressed air
supply filters on the APL
●
Replacing the UDRC filter (for systems that include a UDRC)
●
Replacing the air intake filters for the power box, heat exchanger,
and rear fans
●
Emptying the punch chip collection box (platesetters with the punch
option)
Only authorized service representatives should perform other
maintenance procedures and all service work.
DANGER:
Do not remove any covers bearing the hazardous voltage label. The
covers protect you from contacting hazardous voltage electrical parts that can
cause severe electrical shock, which will result in death or serious injury.
DANGER: Do not remove service access panels. Only authorized service
representatives can safely access areas protected by these panels. Unauthorized
panel removal can expose you to visible and/or invisible high-powered laser
radiation and/or moving mechanical parts, which will result in death or serious
injury.
WARNING: Do not let water or other liquids run freely into the platesetter. This
can result in death or serious injury from electrical shock.
WARNING: Do not use chemical solvents or aggressive cleaning solutions to clean
a compressed air supply filter bowl. This can cause cracking or crazing damage to
the plastic parts. When damaged plastic parts are exposed to high-pressure air, the
parts may explode and cause serious injury.
DANGER: Do not perform unauthorized repairs or make modifications to the
platesetter. Unauthorized panel removal, repairs, or changes can expose you to
visible and invisible high-powered laser radiation, moving mechanical parts, and/or
electrical shock, which will result in death or serious injury.
To Next Page
Loading...
Need help?
General
