LED behaviors Status messages Unit status or possible causes Refer to
and
blink as pattern 1
This error is
displayed when
printer is
unrecoverable.
Software Update failed.
–
If this error has occurred, visit our website at
www.kodakverite.com/ support for the latest
troubleshooting.
“Software update” on
page 43
and
blinks as pattern 1
Paper Jam:
Unplug and replug
the power cable.
A paper jam has occurred inside of the unit.
–
Firmly grasp both sides of the paper, then gently pull it out.
Press and hold
(Power/Standby) longer than 3 seconds
to turn the unit Off (Standby). Unplug the AC plug.
Wait at least 30 seconds, then reconnect the AC plug back
into the AC socket.
●
If this error occurs occasionally, visit our website at
www.kodakverite.com/support for the latest
troubleshooting.
●
If you cannot solve the problem, disconnect the AC
plug and contact an Authorized Service Center.
“Clearing paper jam in
the unit” on page 52.
“Hard Reset” on
page 52.
and/or
blink as pattern 6
blinks as pattern 1
Check cartridge
lock
An ink cartridge is not installed correctly.
–
If the packaging paper is stuck in the Ink door, remove it.
–
Reinstall the cartridge, then close the lid completely.
●
Confirm the ink cartridge is correctly installed, then
press
(Power/Standby).
“Unpack” on page 11.
“Install ink cartridges” on
page 12.
“Changing the ink
cartridge” on page 50.
and
blink as pattern 6
blinks as pattern 1
Remove and re-
insert both black
and color ink
cartridges.
Soiled or unsupported ink cartridge(s) has been inserted.
–
Clean the surface of the nozzles and contacts on the Ink
cartridge(s) with a dampened soft cloth then let them dry
before reinserting cartridge(s).
–
Replace the current Ink cartridge(s) with an authorized Ink
cartridge(s).
“Cleaning the ink
cartridge nozzles and
contacts” on page 53.
“Changing the ink
cartridge” on page 50.
and
blink as pattern 6
blinks as pattern 1
Both inks are
empty.
The ink is empty in the ink cartridge(s).
–
Replace with a new Ink cartridge(s).
●
Order new Ink cartridge(s) from our website at
www.kodakverite.com
“Changing the ink
cartridge” on page 50.
and/or
blink as pattern 6
blinks as pattern 1
No Ink detected
No ink detected.
–
Remove and reinstall the Ink cartridges.
–
Make sure the Ink cartridges are inserted correctly.
–
Clean the surface of the nozzles and contacts on the Ink
cartridges with a dampened soft cloth then let them dry
before reinserting cartridges.
“Changing the ink
cartridge” on page 50.
“Cleaning the ink
cartridge nozzles and
contacts” on page 53.
and
blink as pattern 6
blinks as pattern 1
Both Inks Error
Ink cartridges error.
–
Clean the surface of the nozzles and contacts on the Ink
cartridges with a dampened soft cloth then let them dry
before reinserting cartridges.
–
Replace the current Ink cartridges with authorized Ink
cartridges.
●
If this error occurs occasionally, try to replace the
current Ink cartridges with new Ink cartridges.
“Cleaning the ink
cartridge nozzles and
contacts” on page 53.
“Changing the ink
cartridge” on page 50.
and
blink as pattern 4 and
blink as pattern 4
Both ink levels are
low.
Both inks are low in the ink cartridges.
–
You should purchase a new Ink cartridges.
●
Order new Ink cartridges from our website at
www.kodakverite.com
－
60
English
Continued on next page.
To Next Page
Loading...
