TP-6803 12/11 27Section 1 Installation
tp6809
1. Belden #9402 or equivalent, 20 AWG shielded cable with 2 twisted pairs
PIM
LCM
RXT ATS
1
1
1
Generator Set
TB1
NOTES:
D See Figure 1-6 for terminal block location on generator set.
Check the decal on the generator set for terminal block
connections.
D See Figure 1-21 for maximum total cable length with
12 or 14 AWG wire.
D See Figure 1-22 for communication connection (A and B, PWR
and COM) detail. Connect the cable shield to ground at the
generator set.
Figure 1-25 Accessory Module Connections (two cable runs with one and two modules shown)
To Next Page
Loading...
