4 — PROGRAMMABLE PARAMETERS
Curtis AC F2-A, F4-A, F6-A Motor Controllers – FOS 4.5 – April 2022 Return to TOC
pg. 46
IO ASSIGNMENTS ........................... p. 121
— CONTROLS............................. p. 121
— Interlock Input Source
— Forward Input Source
— Reverse Input Source
— Throttle Source
— Brake Source
— Dual Steer Source
~ EMR State
— EMR Switch Source NO
— EMR Switch Source NC
— Hydraulics Inhibit Type
— Lift Input Type
— Lift Input Source
— Lift Limit Switch Type
— Lift Limit Switch Source
— Lower Input Type
— Lower Input Source
— SWITCH ASSIGNMENT............. p. 123
— Interlock Input Source
— Interlock Input Source Redundant
— Forward Input Source
— Reverse Input Source
— EMR Switch Source NO
— EMR Switch Source NC
— Lift Input Source
— Lower Input Source
— Tow Input Source
— SWITCH STATUS..................... p. 124
~ Switch 1 – 27
— COIL DRIVERS........................ p. 126
— Main Contactor Driver
— EM Brake Driver
— Pump Contactor Driver
— Load Hold Driver
— Lower Driver
EXTERNAL SUPPLIES........................ p. 127
— 5V Output Enable
— 12V Output Enable
~ 5V Measured
~ 5V Supplied Current
~ 12V Measured
~ 12V Supplied Current
~ Total Supplied Current
— Encoder Power Source
— 5V Supply Min Current
— 5V Supply Max Current
— 12V Supply Min Current
— 12V Supply Max Current
CURRENT LIMITS ............................ p. 128
— Drive Current Limit
— Regen Current Limit
— Brake Current Limit
— EMR Current Limit
— Interlock Brake Current Limit
— Pump Drive Current Limit
— Pump Regen Current Limit
— POWER LIMITS.................... p. 128
— Nominal Speed
— Delta Speed
— DRIVE LIMITING MAP... p. 129
— Nominal
— Plus Delta
— Plus 2xDelta
— Plus 4xDelta
— Plus 8xDelta
— REGEN LIMITING MAP.... p. 130
— Nominal
— Plus Delta
— Plus 2xDelta
— Plus 4xDelta
— Plus 8xDelta
OUTPUTS ........................................ p. 126
— Driver Output Frequency
— Coil Supply Start Up Checks
— DRIVER X (1 – 7)................... p. 127
— Driver X Checks Enable
To Next Page
Loading...
Need help?
General
