Kohler DC2 Installation

TP-6984 5/17a 27Section 1 Installation
A
B
COM
PWR
3
4
2
tp6803
1. Generator Set Terminal Block TB3. See Figure 3-5 for location. Check the decal on the generator set for terminal block connections.
2. Splice
3. Connect all of the shield leads on this end to GROUND at the generator set.
Generator Set
COM
PWR
B
A
3
9402 CABLE
9402 CABLE
TB3
RBUS
12 VDC
1
3
COM
PWR
B
A
Figure 1-25 Multiple Connections to the Generator Set
tp6809
PIM
RXT ATS
Generator Set
Notes:
D See Figure 3-6 for terminal block location on generator
set. Check the decal on the generator set for terminal block
connections.
D See Section 1.10.2, Cable Specifications.
D See Figure 1-24 for communication connection detail (A
and B, PWR and COM). Connect the cable shield to
ground at the generator set.
D Use splices or wire nuts to collect multiple leads for
connection to the generator set terminal block. See
Figure 1-25.
Terminal
Block
Load
Shed
Kit
Figure 1-26 Accessory Module Connections (two cable runs with one and two modules shown)

Kohler DC2 Specifications

General

Brand	Kohler
Model	DC2
Category	Portable Generator
Language	English