Valve Settings (cont.)
To enable shower features, such as [Massage], go to the [Settings]
tab, then click on [System]. Safety instructions for each feature
must be read by the homeowner before it is enabled. Refer to
the guide for each feature.
Custom Shower Configurations
NOTE: Custom shower components will need to be selected
manually on the Web page valve menus.
To check or configure valve settings, go to the [Settings] tab, then
click on [Valve 1].
Select the settings for each shower outlet for your system
configuration.
If applicable, click on [Valve 2] to select the outlets for the second
valve.
Complete the Installation
Once components have been configured, test for functionality.
Verify that each component is operating as intended.
For troubleshooting information for each system component, refer
to the guide found on the product page at www.us.kohler.com.
Troubleshooting
IMPORTANT! Turn off the power before performing any
maintenance.
NOTE: For service parts information, visit your product page at
www.kohler.com/serviceparts.
This troubleshooting guide is for general aid only. For service and
installation issues or concerns, call 1-800-4KOHLER.
Controller Troubleshooting Table
Symptoms Probable Cause Recommended Action
1. System stops
working and
the status LED
is solid red.
A. System failure. A. Reboot the controller
by disconnecting the
AC power from the
wall outlet. If the
status LED remains a
solid red after reboot,
replace the controller.
1218131-2-A 14 Kohler Co.
To Next Page
Loading...
Need help?
General
