1. Preparation
NOTE: The controller powers the interface(s) and controls system
components such as digital mixing valve(s).
Your system can be set up to use three interfaces. One interface,
installed inside the shower, is required.
Determine the locations of all components, including shower
accessories. For pre-programmed shower configurations, refer to
the guide found on the product page at www.us.kohler.com.
Refer to the installation guides packed with each product for
specific installation needs.
Before Operating the System For the First Time:
Download and install the latest software for connected components.
This may take an hour or more to complete based on system
configuration and internet connection speed. Do not disconnect the
power from the controller during software download and
installation.
Internet
Service
Router
Computer
or Tablet
Shower AccessoriesWater Inlets Interfaces
Controller
25' (7.6 m) Ethernet Cable
Power Supply
72" (1.8 m) Cord
48"
(1219 mm)
Cord
Digital
Valve
Digital Valve
Kohler Co. 5 1218131-2-A
To Next Page
Loading...
Need help?
General
