2. Connect the Hoses
CAUTION: Risk of restricted water flow and product damage.
Supply hoses must not be taut, kinked, or twisted during
installation. If the supply hoses must be coiled, maintain an inside
diameter of 3″ (76 mm).
Connect the Supplies
Connect and tighten the supply hoses to the supply stops.
Place a bucket under the outlet hose.
Turn on the water supplies.
Flush hot and cold water into a bucket for 1 minute to remove
any debris.
Outlet Hose
Ø 3"
(76 mm) Min
Supply
Hose
1281441-2-C 6 Kohler Co.
To Next Page
Loading...
Need help?
General
