To Next PageTo Next Page
Need help?Do you have a question about the Kold-Draft GT564LC and is the answer not in the manual?
Details making all plumbing and electrical hookups.
Details the controller and various switches like On-Off and Ice-Clean.
Provides detailed interpretation of fault codes based on software revision.
Describes the steps in the normal ice making cycle.
Explains the individual steps of the ice making cycle.
Safety precautions and general notes for compressor testing.
Procedures to test for ground faults and winding continuity/resistance.
Steps to test potential relay, run capacitor, and start capacitor.
Includes tests for thermal protector, wiring, and potential relay.
Instructions for aligning the water plate with the evaporator.
Details on adjusting the water plate's open/closed positions.
How to test water level probes for continuity.
Testing resistance values of temp and ice level probes.
Lists causes and solutions for the ice machine not running.
Diagnoses issues when only the compressor fails.
Troubleshooting for the condenser fan motor.
Addresses slow defrost and related problems.
Addresses issues causing poor ice quality.
Step-by-step guide for assembling and installing the crusher.
Prerequisites and checks before condenser installation.
Guidance on calculating and verifying system refrigerant charge.
General| Power Supply | Electric |
|---|---|
| Condenser | Air Cooled |
| Voltage | 115V |
| Ice Storage | Not Included |
| Water Connection | 3/8" FPT |
| Refrigerant | R-404A |
| Ice Type | Cube |
