To Next PageTo Next Page
Need help?Do you have a question about the Kold-Draft GT564AC and is the answer not in the manual?
Detailed descriptions of fault codes and their meanings.
Troubleshooting steps for various fault codes based on controller revision.
Troubleshooting for high evaporator temperature fault.
Troubleshooting for water plate failure to close.
Troubleshooting for freeze cycle duration errors.
Troubleshooting for short freeze cycles.
Troubleshooting for long harvest cycles.
Troubleshooting for water fill time errors.
Troubleshooting for low evaporator temperature during fill.
Crucial safety advice before testing compressors.
Procedures for testing compressor electrical components.
Procedure to detect ground faults in the compressor.
Testing compressor winding continuity and resistance.
Procedure for testing the compressor's potential relay.
Procedure for testing the run capacitor.
Procedure for testing the start capacitor.
Instructions for aligning the water plate with the evaporator.
Guide to adjusting the water plate's up and down positions.
Solutions for when the ice machine is not running.
Troubleshooting for compressor issues when other components work.
Steps to fix the water plate not closing after defrost.
Diagnosing why defrost doesn't start when water level is low.
Causes for defrost cycle ending before ice is out.
Troubleshooting for the water valve not closing during fill.
Important notes and safety warnings for crusher installation.
Checklist of requirements before installing the ice crusher.
Steps for assembling and installing the ice crusher onto the ice maker bin.
Wiring the safety switches for the crusher and ice maker.
Steps for physically installing the remote condenser unit.
General| Brand | Kold-Draft |
|---|---|
| Model | GT564AC |
| Category | Ice Maker |
| Language | English |
