Kold-Draft GT564AC - Ice Cuber Safety Information; General Safety Precautions

new 60 Series Service Manual.rev. 06.01.16.docx - 1 –
ICE CUBER-SAFETY INFORMATION
Special attention should be given to potential hazard labeling on the equipment and the signal
words and symbols that are used throughout this manual. They may also be used to alert against
unsafe practices
Note: Note is used to notify personnel of installation, operation or maintenance information which
is important, but not a cause of personal injury or property damage.
Warning: Indicates a potentially hazardous situation that may result in minor or moderate
injury. The situation may also cause minor damage to the machine
Caution: Indicates a potentially hazardous situation that could cause serious injury or death.
The situation may also critically damage the machine
DANGER: Indicates a potentially hazardous situation that could cause serious injury or death.
The situation may also critically damage the machine
Note:
• Check for freight damage before proceeding with the equipment installation. Be sure to
inspect the equipment carefully for any damage that may not have been evident on the
outside of the carton. Contact the freight carrier immediately to report any damage and file a
claim.
• Read the entire manual before installing, operating or servicing the machine
• To ensure optimal efficiency and productivity follow these installation instructions exactly.
• All machines have been tested and adjusted for correct performance at the factory.
• Knowledge of proper installation and service procedures is essential for the safe operation
and maintenance of KOLD-DRAFT equipment. Refer all installation and service work to
qualified technicians.
• This equipment must be installed in compliance with the applicable federal, state/province,
and/or local plumbing, electrical, and health/sanitation codes and requirements.
• Always disconnect the power supply before servicing the equipment or when the equipment
will not be used for a period of time. Some circuits remain energized when the machine is
switched off.
• Never operate equipment that has been damaged or does not have all the protective covers
in place.
• Never operate equipment that has been altered from the original KOLD-DRAFT
specifications.
• Use of non-approved parts when servicing KOLD-DRAFT equipment will void the equipment
warranty.
Warning: Use only genuine KOLD-DRAFT replacement parts, Use of non-approved parts
when servicing KOLD-DRAFT equipment may create a safety hazard, cause
equipment damage, property damage and will void the warranty.