To Next PageTo Next Page
Need help?Do you have a question about the Kold-Draft GT561AC and is the answer not in the manual?
Lists precautions for installation, operation, and service to prevent hazards.
Explains the components and meaning of KOLD-DRAFT model numbers.
Lists critical safety warnings and precautions for installing the ice cuber.
Details ambient temperature, opening sizes, and location considerations.
Specifies requirements for drain connections, water supply, and pressure.
Outlines permanent connection, dedicated circuits, and fused disconnects.
Details the process of assembling the ice machine and bin.
Highlights the need for multiple people during assembly to prevent injury.
Steps to take before powering on the machine for the first time.
Verifying water plate movement and initial ice-making cycle.
Instructions for mixing the cleaning and sanitizing solutions.
Detailed steps for running the cleaning and sanitizing cycles.
Lists normal operating pressures for refrigerant in various cycles.
Lists fault codes and the conditions that trigger them.
Provides detailed explanations for various fault codes (e.g., >40, >50, >60).
Describes the stages of the ice making cycle and controller inputs/outputs.
Details control statuses for ice bin full and cleaning modes.
Provides an overview of the ice making cycle stages.
Explains the water fill stage of the ice making cycle.
Describes the freezing stage and water return during ice making.
Explains the lowering of the water plate for ice release.
Criteria the controller monitors for starting the ice making mode.
Procedure to check for short circuits to ground in the compressor.
Tests for continuity and proper resistance in compressor windings.
Details testing procedures for potential relay and run capacitor.
Outlines methods for testing the start capacitor.
Step-by-step instructions for removing and replacing the water plate.
Provides tests and parameters for troubleshooting the actuator motor.
Procedure for testing water level probes for continuity.
How to test evaporator and ice level probes using resistance values.
Solves issues when the ice machine is not running.
Solves issues when the compressor is not operating but other parts are.
Lists crucial safety precautions for operating the ice crusher.
Checklist for electrical requirements and voltage tolerances for crushers.
Step-by-step guide for assembling and installing the ice crusher.
Explains the operation of the crusher in crushed and cube modes.
Step-by-step guide for cleaning the ice crusher.
Checklist for electrical, ambient, and installation requirements.
Step-by-step instructions for installing the condenser.
Guide to calculating the total refrigerant charge for the system.
General| Brand | Kold-Draft |
|---|---|
| Model | GT561AC |
| Category | Ice Maker |
| Language | English |
