Kold-Draft GB561AC - User Manual

- -
Installation, Operation, Technical
Service and Replacement Parts Manual
Ice Cube Makers - GT36x, GT56x, GB56x, GB106x
Stacking Instructions - Multiple GB56x or GB106x
Ice Cube Crushers - T27x
Pre-charged Remote Air-Cooled Condenser - RC214APV
GT36x GT56x GB56x GB106x
KDIndustries, Inc.
1525 East Lake Road
Erie, PA 16511-1088 U.S.A.
(800) 840-9577
FAX: (800) 548-9392
www.kold-draft.com
November 2016
This manual is updated periodically. Visit http://www.kold-draft.com/resources/literature.php for the latest version.

Summary

ICE MAKER IDENTIFICATION

ICE CUBER INSTALLATION

Pre-Install Checklist

Checklist of requirements before installing the ice machine.

ASSEMBLY

Assembly Procedure

Step-by-step guide for assembling the ice machine and bin.

INITIAL START PROCEDURE

ICE MACHINE CLEANING PROCEDURE

COMPONENTS

Mechanical Components

Controller

Fault Codes

Lists fault codes and their meanings for the ice machine.

ERROR-CODE TROUBLESHOOTING

Evaporator Temperature Over 120 F

Troubleshooting for evaporator temperature exceeding 120F.

Water Plate Failed to Close (Rev. 1.1)

Troubleshooting for water plate failing to close after multiple attempts.

Water Plate Failed to Close (Rev. 1.2;1.3)

Troubleshooting for water plate failing to close after multiple attempts.

Freeze Time Exceeds 60 Min. (Rev. 1.1;1.2)

Troubleshooting for freeze cycle exceeding 60 minutes.

Freeze Time Exceeds 45 Min. Three Times Consecutively (Rev. 1.3)

Troubleshooting for freeze cycle exceeding 45 min. three times.

Freeze Time Less Than 5 Min. for 3 Consecutive Times

Troubleshooting for freeze time less than 5 min. for 3 consecutive times.

Harvest Cycle Exceeds 20 Min.

Troubleshooting for harvest cycle exceeding 20 minutes.

Evaporator Temperature < 31 F During Water Fill

Troubleshooting for low evaporator temp during water fill.

Arm-Up;Arm Down Switches Closed Simultaneously

Troubleshooting when Arm-Up/Arm Down switches are closed together.

Ice Bin Full Condition

SEQUENCE OF OPERATION

Ice Making Sequence

START METHODS

Ice Making Mode Start Up

GT36 X, GT56 X, GB56 X Wiring Diagrams

GB1064 A & L Wiring Diagram

GB106 XR Wiring Diagram

COMPRESSOR TEST PROCEDURE

Test Procedure for Ground Fault

Procedure to test for short circuits to ground on the compressor.

Test Procedure for Continuity and Resistance

Procedure to test compressor winding continuity and resistance.

Testing the Potential Relay

Testing the Run Capacitor

Testing the Start Capacitor

WATER PLATE REPLACEMENT

WATER PLATE ALIGNMENT

WATER PLATE UP;DOWN POSITION AND ADJUSTMENT

PROBE TEST PROCEDURE

Water Level Probes

Evaporator Temperature and Ice Level Probes

TROUBLE SHOOTING

Ice Machine Not Operating

Troubleshoot issues when the ice machine is not functioning.

Compressor Not Operating (Other Components Normal)

Troubleshoot compressor issues when other parts are working.

Condenser Fan Motor Not Operating (Air-Cooled)

Slow Defrost Performance

Water Plate Re-opens Immediately After Closing

Water Plate Closes Then Re-opens Before Water Fill

Water Plate Will Not Close After Defrost

Defrost Does Not Initiate When Water Level is Low

Defrost Cycle Ends Before Ice Ejection

Defrost Valve Opens During Water Fill

Ice Remains Attached to Water Plate After Defrost

Water Valve Will Not Close (Water Level Continues to Rise)

Water Valve Will Not Open (Water Level Not Reached)

Poorly Formed or Cloudy Ice Cubes

Ice Cubes Do Not Break Apart After Defrost

Uneven Dimples (Low Refrigerant Charge)

Uneven Dimples (High Evaporator Superheat)

Uneven Dimples (Low Evaporator Superheat)

Actuator Motor Turns Clockwise at Start of Defrost

Cam Arms Improperly Positioned

PARTS LIST

ICE CUBE CRUSHERS - T27 X

ICE CRUSHER SAFETY INFORMATION

Safety precautions specific to the ice crusher unit.

ICE CRUSHER INSTALLATION

Installation guide for the KOLD-DRAFT ice crusher.

Assembly;Installation

Step-by-step assembly and installation of the ice crusher.

ICE CRUSHER OPERATION

ICE CRUSHER CLEANING PROCEDURE

PRE-CHARGED REMOTE AIR-COOLED CONDENSER - RC214 APV

Remote Air-Cooled Condenser Installation

Installation guide for the remote air-cooled condenser.

Remote Air-Cooled Condenser Specifications

Minimum Total Charge Required

Guidelines for the total refrigerant charge for the system.

Kold-Draft GB561AC Specifications

General

Type	Ice Maker
Model	GB561AC
Production Capacity (24h)	560 lbs
Voltage	115V
Refrigerant	R-404A
Condenser	Air-Cooled